SET of 2 Silicone newest Molds, Miniature Syringe Mold and Capsule Pill Mold, Handmade Two Part 3D Mold, for UV Resin and Jewelry Making, Japan

Set contents:
1x Syringe Injector Mold Set
1x Capsule Pill Mold Set

-------------------------------------------------

Measurement of completed syringe
Outer diameter of syringe 1cm wide (0.39 inches)

Measurement of completed capsule pill:
Approximately 1cm width in diameter (0.39 inches diameter)

Made in Japan
Handmade
Material: Silicone

Check out other molds here: http://etsy.me/2EMeQaM

Tips for maintaining life of silicone molds:

- Demold as soon as the resin is cured newest to help the mold last longer
- Always apply a mold release agent and let it sit on the mold for 20 to 30 minutes before putting resin into the mold
- After demolding, gently wipe the silicone mold surface that was in contact with resin previously using alcohol tissue so that there is no residual resin or paint
- Store it at room temperature away from sunlight (sunlight can break down silicone overtime)
- Avoid using a torch or fire over the resin (some people do this to remove surface bubbles) as the high temperature of a direct flame may break down the silicone
- UV-resin is preferred to epoxy as the curing time is shorter
- We highly recommend using an industrial mold release agent
- Avoid leaving resin inside the mold for too long as it will naturally degrade the silicone, especially if paint is added into the mix